点击图片查看原图
4-6 m bending machine use method
1, the first is to turn on the power supply, open the key switch on the control panel, and then press the oil pump to start, so that you can hear the sound of the oil pump. (The machine does not move at this time)
2, stroke adjustment, the use of the bending machine must pay attention to the adjustment of the stroke, must be tested before bending. There must be a gap of plate thickness when the bending machine dies run down to the very bottom. Otherwise, it will cause damage to the mold and machine. The adjustment of the stroke is also electric quick adjustment and manual stomach adjustment.
3, bending notch selection, generally to choose 8 times the width of the plate thickness of the notch. If bending 4mm sheet material, choose about 32 notches.
4, the rear stopper adjustment generally has electric rapid adjustment and manual fine-tuning, the method is the same as the shearing machine.
5, step on the foot switch to start bending, bending machine and shearing machine is different, you can loosen at any time, loosen the foot bending machine will stop, continue to go down. 15690126655
